Operator`s manual

22. Install the ORB connector, 1, to the front port of

the three-point hitch valve slice, 2. Tighten the

fitting securely.

10000657

23. In the rear of the valve section install the straight

threadedadapter,1,intothe upper port.This port

is marked “OUT”. Tighten the fitting securely.

24. Install the 90_ elbow, 2, into the bottom port on

the rear of the valve slice. This port is marked

“IN”. T ighten the fitting securely.

20000658

25. On all 80 series HydraFlow equipped, 9482,

9682, 9882, 9384, 9484, 9684, 9884, 2270,

2310, 2360, and 2425 tractors, install the

connectorfitting,1,andcheckvalve,2,(removed

in step 3 of this procedure). There is an o-ring on

thecheckvalvethatcanbecutoffanddiscarded.

The check valve is a multi purpose fitting (ORB

and JIC) and the o-ring is not used to seal this

connection.

Be certain that the check valve is orientated so

that the flow arrow on the check valve points

toward the implement valve.

20000659