Operator`s manual

14. On 80 Series with HydraFlow, 82, 84 and 2000

Series tractors, installthe elbow fitting,1, intothe

outlet end cap and tighten securely. When

orientated properly, the open end of the elbow

will face the engine.

NOTE: The elbow fitting that comes in the 3PT Hitch

Kit is part #V70253. This elbow fits all 80/82/84/2000

series models EXCEPT 9282, 9184 and 2240

tractors.Ifthetractorbeingworkedinisa9282, 9184

or 2240, elbow part#86014503 mustbe ordered and

installed.

NOTE: If the tractor being worked on is an 80 series

Non-HydraFlow tractor, elbow V70253 and/or

86014503 are not used. Straight fitting 139398 must

be ordered and installed in place of the elbow.

139398 is not included in the kit.

10000651

15. On 80 Series tractors without HydraFlow install

the straight fitting, 1, into the end cap and tighten

securely.

10000652

16. Remove the wood block from under the valve

assembly and reposition the valve stack

properly. When aligned, install the cap screws

and lock nuts, 1, which were removed in step 5

ofthisprocedure.Tightenthehardwaresecurely.

NOTE: Be certain to reposition the implement valve

assembly on the rear frame as identified in step 5 of

this procedure. The right hand side cap screw will

remain in the same position. The left hand side cap

screwwillmoveonepositiontotheleftbecauseofthe

additional valve slice installed.

Make certain that the wiring harness is not

pinched under the valve stack. Move it side to

side to make certain it is free.

17. Reconnect the flow control cables to the

bellcrank on the front of the valve sections.

10000653