Operator`s manual

11. Replace the four o-rings, 1, and three shims, 2,

located on the blue valve section. Make certain

that the new o-rings are properly seated in the

grooves.

10000648

12. Installthethree-pointhitchvalveslice,1,ontothe

through bolts. Install new o-rings, 2, and shims,

3, to the outside of the three-point hitch valve

slice. Make certain that the o-rings are seated

properly in the grooves.

10000649

13. Install the end cap, 1, onto the implement valve

assembly. Install a lock washer and nut on each

through bolt, 2. Torque the hardware to 29 N⋅m

(22 ft. lbs.).

NOTE: If the tractor being worked on is an 80 Series

non HydraFlow tractor install the end cap that is

contained in this kit. If the tractor being worked on is

an80series HydraFlow,82Series, 84series or2000

Series the end cap contained in the kit will not be

used. Reinstall the original end cap removed in step

#10.

IMPORTANT: Torque the nuts to a maximum of 29

N⋅m (22 ft. lbs.). Do not over tighten the nuts as this

will cause the valve spools to bind.

10000650