Operator`s manual

19
\
8. Install the new through bolt, 1, tothe valve stack,
2,bypushingtheboltthroughthevalveassembly
from left to right. Install a new lock washer and
nut on the right hand side of the through bolt.
NOTE: By removing one through bolt at a time the
valve seals will not be disturbed and will not have to
be replaced. If you cannot remove each through bolt
oneat a time, the valve assembly must be separated
andnewsealsmustbeinstalled.Asealkitisincluded
with the three-point hitch kit.
10000645
2
1
44
9. Repeat steps 6 through 8 for each of the two
remaining through bolts, 1.
10000646
1
45
10. Remove the outlet end cap, 1, from the
implement valve assembly, 2.
Ifthe tractor beingwork onis an80Seriestractor
withanon HydraFlow hydraulicsystem(endcap
is not ported) discard the end cap.
If the tractor being work on is an 80 Series
HydraFlow, 82 Series, 84 Series or 2000 Series
tractor, retain the end cap for installation later in
this procedure.
10000647
1
2
46