Operator`s manual

4. On the front of the implement valve assembly

unsnap the flow control cables, 1, from the

bellcrank, 2.

NOTE: 80 series tractors will have one flow control

cable standard. 82 series tractors can have one flow

control cable or an optional four flow control cables.

84/2000Series tractors have four flowcontrolcables

as standard equipment as shown.

5. Removetheimplementvalvefromtherearframe

ofthetractorbyremovingthetwocapscrewsand

lock nuts, 1. Retain the hardware for reinstalla-

tion. Tilt the valve stack up to the right and place

a block of wood under the valve assembly.

NOTE: Note the bolt hole location where the

implement valve assembly was mounted to the rear

frame. There are three possible locations depending

on the series of tractors and number of flow control

cables.

10000643

6. From the right hand side (inlet end) of the

implementvalve removethe nutandlock washer

from the top center through bolt.

7. Gentlypullthetopthroughbolt,1,outofthevalve

stack towards the left (outlet) side of the tractor.

10000644