Operator`s manual

SECTION 2

HYDRAULIC COMPONENT INSTALLATION

NOTE: 80 Series non HydraFlow tractors do not

have a supplemental supply line on the outlet end

cap.Skipsteps#1,#2and#3andproceedtostep#4.

1. Disconnect the implement valve supply line, 1,

from the elbow fitting, 2, on the left hand side of

the implement valve stack (outlet end), 3.

NOTE: Have a drain pan available to catch any

excess fluid in the supply line.

10000640

2. Remove the elbow fitting, 1, from the check

valve, 2, and discard it at this time.

NOTE: On 9282, 9184 and 2240 tractors the elbow

is screwed into the end cap and the check valve is

screwed into the elbow. Remove both fittings as

detailed in step #2 and #3.

10000641

3. Remove the check valve, 1, from the implement

valve end cap, 2. Retain the check valve.

10000642