Operator`s manual

28. Install the left hand side sway block, 1, to the

outside of the drawbar cage, 2. Secure the sway

block with two 3/4 - 10 UNC x 1 3/4 cap screws

and hardened flat washers, 3. Torque the

hardware to 270 N⋅m (200 ft. lbs.).

29. For additional information on the sway block

positioning, refer to the appropriate tractor

Operator’s Manual.

30. Repeat step 28 for the right hand side sway

block.

20000632

31. Align the right hand side lift link, 1, to the

rockshaft arm, 2, and align two spacers, 3,

between the lift arm and the rod end of the link.

Secure the lift link with the upper lift link pin, 4.

The pin must be installed from the inside of the

rockshaft arm outward. Secure the pin with an

M10 x 25 shoulder bolt, 5. Torque the hardware

to 54 N⋅m (40 ft. lbs.).

20000633

32. Install the lower link, 1, to the drawbar cage, 2,

with a spacer, 3, to the inside of the lower link.

Install the lower lift link pin, 4, through the lift link,

spacer and drawbar cage.

NOTE: The lower link weighs approximately 50 Kgs

(110 lbs.). Use caution when installing onto the

tractor.

20000634