Operator`s manual

11
\
19. Using a proper lifting device, align the drawbar
cage, 1, to the rear frame of the tractor and
secure it with twelve M20 x 60 cap screws and
M20 flange nuts, 2. When the cage is aligned
properly, move the lifting device away from the
tractor. Torque the hardware to 960 N⋅m (706 ft.
lbs.).
NOTE:Thedrawbarcageweighs approximately 230
Kgs. (510 lbs.). Use caution when installing cage to
the rear frame of the tractor.
30000626
1
2
22
20. Using a floor jack align the drawbar, 1, to the
cage, 2, and install the bridge plate, 3. Install the
cap screw and washer, 4, to secure the bridge
plate to the drawbar and torque it 960 N⋅m (706
ft. lbs.). Install the stanchion pins, 5, and install
the klik pins, 6, to secure the drawbar.
20000627
3
6
1
4
2
5
23
21. Install the drawbar clevis, 1, and secure with two
capscrewsandwashers,2.Torquethehardware
to 960 N⋅m (706 ft. lbs.).
20000628
2
1
24