Quick Start Guide

16 T50 INFINIUM Quick Start Guide 17
T50 INFINIUM Controls
(1) (2) (6) (9) (11) (12) (13) (14) (15)(3) (7)(5) (10)(4) (8)
(16)(21) (22) (18) (19)(17) (20)
(EN) Step 2: Controls
(1) INPUT – connect your guitar to this jack.
(2) CLEAN GAIN knob adjusts the amount of
gain for the clean channel, delivering mild
overdrive at high settings.
(3) CLEAN LED indicates that the clean channel
is selected.
(4) CLEAN EQ knobs adjust the high, middle
and low frequencies for the clean channel.
(5) CHANNEL button selects between
the Clean and Lead channels.
(6) LEAD GAIN knob adjusts the amount of gain
and overdrive for the lead channel.
(7) LEAD LED indicates that the lead channel
is selected.
(8) LEAD EQ knobs adjust the high, middle and
low frequencies for the lead channel.
(9) LEAD VOLUME knob adjusts the volume for
the lead channel, allowing the relative level
to be balanced with the clean channel as
desired.
(10) PHAT button engages a boost that aects
both channels.
(11) REVERB knob adjusts the amount of reverb
eect. The adjacent LED will light when the
eect is active.
(12) TONE CUT knob removes some of the high
frequencies for a rounder tone.
(13) MASTER POST PHASE INVERTER volume
control adjusts the nal output volume.
This control allows you to capture the full
harmonics generated in the phase inverter
stage even at moderate volumes.
(14) STANDBY switch mutes the amp's output
and preserves your amp's power tubes.
(15) MAINS The jewel lamp lights when the
power is on and ashes to indicate an error.
See innium advice for details.
(16) INFINIUM LEDs will light when the power
tubes need to be replaced. The power
section can accept EL34 or 6L6 tubes, and the
stock 12AX7 preamp tubes can be replaced
with other variations.
(17) LOUDSPEAKER OUTPUT jacks allow
connection of a speaker cabinet. Always use
speaker cable for this connection!
(18) IMPEDANCE
switch selects between 4, 8 and 16 Ohms.
(19) FOOTSWITCH jack allows connection of the
included footswitch.
(20) FX LOOP jacks allow connection
of eects devices.
(21) MODE switch selects between smooth class
A or highly-responsive class AB operation
with tighter bottom end.
(22) EMULATED DI OUT jack allows direct
connection to a line input for recording or
live mixing. The signal emulates the sound
of either a 1x12 or 4x12 cabinet, selectable
via the adjacent button. This output works
even when the amp is in Standby, and it
is independent from Tone Cut and Master
volume controls.