Quick Start Guide

16 G5 INFINIUM Quick Start Guide 17
(1) (2) (3) (4) (5) (6) (7) (8) (9) (10) (11)
(12) (14) (15) (17)(13) (16) (18) (19)
(EN)
Step 2: Controls
(1) POWER switch turns the amp on and o.
The jewel lamp lights when power is on and
ashes to indicate an error. See Innium
advice for details.
(2) STANDBY switch mutes the amp’s output
and preserves your amp’s power tube. Put
the amp into STANDBY mode when you are
practicing via headphones rather than via
speaker cabinet.
(3) REVERB knob adjusts the amount of
reverb eect.
(4) MORPH knob blends the tonal character of the
overdrive channel from an American style to
a British avor. Theeect of this knob is more
subtle when the MIDDLE knob is at the center
12:00 position, and more pronounced with the
MIDDLE set very high or very low.
(5) EQ knobs adjust the low, middle, and high
frequencies of the guitar tone.
(6) OVERDRIVE VOLUME knob adjusts the volume
level of the overdrive channel.
(7) GAIN knob adjusts the amount of distortion
on the overdrive channel.
(8) CHANNEL button switches between the clean
and overdrive channels.
(9) TONE knob adjusts the brightness of the
clean channel.
(10) CLEAN VOLUME knob adjusts the volume level
of the clean channel.
(11) INPUT – connect your guitar to this jack.
(12) LINE input allows connection of external audio
sources for jamming and practicingpurposes.
(13) EFFECTS LOOP SEND and RETURN jacks allow
connection of eects devices. Use the LEVEL
button to select +4 dB for use with rack eect
processors, or the -10 dB setting for use with
stompboxeects.
(14) FOOTSWITCH input allows connection of the
includedfootswitch.
(15) EMULATED OUTPUT jack allows connection
of headphones or a line out for recording. The
signal emulates the sound of either a 1x12
or 4x12 cabinet, selectable via the adjacent
button. This output works even when the amp
is in Standby. The attenuator and power stage
do not aect this signal.
(16) POWER ATTENUATOR switch allows the amp
to be run at 5 Watts, 1 Watt, or 0.1 Watts.
(17) AMPLIFIER OUTPUT jack allows connection of
an 8 Ohm speaker cabinet. Alwaysuse speaker
cable for this connection!
(18) INFINIUM LED will light when the power tube
needs to be replaced. Alwaysuse a 12BH7
power tube. TheECC83A preamp tube may be
replaced with other variations though.
(19) IEC SOCKET accepts the included power cable.
Bugera G5 INFINIUM Controls