User Manual

BUGERA TRIREC
Boutique-Style All-Valve Guitar Amplifier Head
Boutique-Style 100-Watt 3-Channel Valve Ampli er Head
with Tri-Mode Recti er, Reverb and Varipower
Features
The Back Story
The TRIREC’s incredible tonal variations
make it a recording studio gem, but it’s
got the features that make it equally
amazing on stage. The back panel features
a LINE OUT jack with dedicated Level knob
for sending signal to a slave amp, as well
as Loudspeaker jacks with switchable
impedance (16, 8 or 4 Ohms), making this
ampli er compatible with virtually any
speaker cabinet.
The built-in FX Loop has controls
for adjusting the output (send) and
return levels separately. The associated
Assign knob has four states: FX loop is
always on, has an individual status per
channel, is activated via footswitch,
or is deactivated. You also get six
External Switching jacks that allow channel
switching, BOOST, REVERB and FX LOOP
to be controlled by an external switching
system. This is where you’ll  nd the input
for the FSB106A footswitch, which also
controls these parameters, and o ers a
MIDI IN /THRU connection controlling the
TRIREC in sync with your MIDI setup.
Rectify Your Situation
“Heavy” is a relative term. The walls of
amps at Woodstock? Heavy. The stacks used
in modern metal? Colossally heavy. Yet
neither  avor of heavy shows any signs of
going out of style. This amp is loaded with
brutal power, but it can also be tamed with
unprecedented ease. Harness the power of
valve-based recti ers or silicon diodes in a
single amp, or combine them for the best of
yesterday and today with the TRIREC. Give
your tone the power it deserves – plug into
a TRIREC at your nearest BUGERA dealer.
Rear Panel
ASSIGN knob options:
• ON – e ects loop is always active
• CHANNEL – FX LOOP on/o status
is stored for each channel
• REMOTE – FX LOOP is turned
on and o with footswitch
or EXTERNAL SWITCHING jack
• OFF – FX LOOP is deactivated
LINE OUT
adjusts level of
OUTPUT jack
for use with
slave amp
EXTERNAL SWITCHING
jacks allow channel
switching, BOOST,
REVERB and FX LOOP to
be controlled by external
switching system
RECTIFIER selects
between silicon
diode, valves, or
combination
LEVEL adjusts
level of signal
coming in
through RETURN
jack
SEND adjusts
output level
of FX LOOP
SEND jack
IMPEDANCE
selects
between 4, 8
and 16 Ohms