Operation Manual
27
For conversion table for °Fahrenheit and altitude’s temperature difference see the inner cover
Troubleshooting
If the Vera kettle develops faults or defects or if irregularities are suspected, unplug it immediately. If
you cannot eliminate the fault by following the instructions in this manual, contact Customer Care at
CASA BUGATTI. Repairs carried out incorrectly expose the user to grave danger. No liability is accepted
for damage or injury caused by repairs carried out incorrectly and in such cases warranty rights are
voided.
The display on handle
doesn’t switch on
Il display does not show
proper information
The watel level light are
on without water inside
the kettle.
The kettle does not work
properly or stops before
boiling.
If the water tastes bad.
The kettle, after pressing
the button on/off(14)
does not start to heat.
The water inside the
kettle, during the heating,
comes to the boil but the
temperature shown on the
display on the handle is
lower than 99°C.
The kettle is not well
positioned on the power
base (5) and the plug (6)
is not well insert in the
socket . The rechargeable
battery is still not
correctly charged.
The kettle does not work
for long time
There is lime scale on the
water level sensors
There is lime scale into
the kettle
Water is in the kettle for
more then 12 hours - The
kettle is not well washed
after the descaling cycle
The water level inside
the kettle is lower than
“800ml” and the blue light
“ml minimum”, on the
display on handle, blinks.
The kettle is used at an
altitude over 500/1000
meter on the sea level
Trouble Possible Cause Solution
“Check if the plug (6) of the power base (5) is well
connected to the wall socket. Check that there is
electricity in your system. Remeber, before operating
the kettle, please fully charge the battery for 12
hours.”
Make the RESET function for the display as per Special
instruction of this manual
Make the RESET function for the display as per Special
instruction of this manual and if the problem does
not leave make the descaling as per point b) of the
Cleaning and maintenance chapter.
Make the descaling as per point b) of the Cleaning and
maintenance chapter.
We suggest to change the residual water after each
boiling cycles. Rinse the kettle sufcient time in order
to remove completely the descaling product
Fill the kettle with water till, on the display, the blue
light of the level “ml minimum” stop to blink and the
blue light of the level “800ml” is on.
Have a look to the third cover page instruction:
ALTITUDE WATER BOILING TEMPERATURE during the
BOIL FUNCTION.