Specifications

19
The motor does not start
to turn
The motor starts to run
but the blade does not
turn.
Some drops of food splash
out from the jug
The plug(17)is not well
inserted into the socket
The power supplied
does not correspond to
the rating label of the
appliance
The button on/off (2) is
not yet activated
The hand safety sensor (7)
is not tightly covered by
the palm of your hand.
The start button(6) is not
properly pressed.
The blender bar (9) is
not well inserted into the
motor unit (3) .
The level of food into
the jug is over the
maximum blending level
Check if the plug (17)
is well inserted into the
socket
Check if the plug (17) is well inserted into the socket
Check if there is power in your system
Press on/off button to switch on the motor unit (3)
Make sure that the palm of your hand is well
covering the surface of the hand safety sensor (7).
Make sure that the start button (6) is well pressed by
your index or middle nger.
insert the Blender Bar (9) till the bottom of the
motor unit (3) until you hear a “click” sound.
Make sure that the food level is not over the maximum
blending level marked on the jug that corresponding
to 350ml.
Trouble Possible cause
Solution
Troubleshooting
If the Eva Hand Blender develops faults or defects or if irregularities are suspected, unplug it immediately.
If you cannot eliminate the fault by following the instructions in this manual, contact Customer Care
at CASA BUGATTI. Repairs carried out incorrectly can expose the user to serious harm. No liability is
accepted for damage or injury caused by repairs carried out incorrectly and in such cases guaranty rights
are voids.
SPARE PARTS
The following parts can be simply ordered and replaced by yourself:
Motor Unit (3) code: 16EVA003/.. (COUNTRY)
Blender Bar (9) code: 16EVA009 - Blade set of 3 pcs : 16EVA011/3 - Blender stand (10) code :
16EVA010/.. (Colour)