Setup guide

8. Apple Installation

Your Apple Computer must either have an Airport card or PCMCIA wirelesses card that is

802.11b compliant installed.

1. Turn on your Computer.

2. Click the Apple icon on your toolbar and Select Airport.

3. In the Airport Network window, select Network area.

4. Find a 6-character ID number with the word GROUP attached to it and click it.

5. Click the Apple icon on your toolbar. Select Control Panel, and then click TCP/IP.

6. Verify that it says, Connect via Airport at the top.

7. Set the configuration to Manual. Set the IP address to 1.1.1.2, the subnet mask to 255.255.255.0.

and leave the router address Blank. For the Local Router, use IP Address 192.168.0.2

8. Open up a Web Browser to connect to the Airstation Accesspoint through IP Address and follow the

wizard setup. Use 1.1.1.1 for the Router and 192.168.0.1 for the Local Router.

9. Follow the instructions to set up the Airstation Accesspoint from the Router or Local Router section.

10. Click the Apple icon in your toolbar. Select Control Panel, and then click on TCP/IP.

11. Change the configuration to DHCP if you have a DHCP server on your LAN or leave it on the

manual setting and configure it to your LAN settings.

12. Close the TCP/IP window and save when prompted to.

13. This should give you connection to your Internet and/or your wired LAN.