User manual

25
◗ Now that the WBR2-G54 and wireless client adapter are
installed,youcanuseAOSStocongurethem.
◗Tobegintheconguration,presstheAOSSbuttonon
the back of the WBR2-G54 for 3-5 seconds. The AOSS
lightwillbegintoashwhentheAOSSmodehasbeen
enabled. You can stop pressing the button at this point.
n NOTE: AOSS mode will stay active for a period of
two minutes. This is the time-slot required to initiate the
wirelessclientadapter.TheAOSSLEDwillstopashing
when AOSS mode has stopped or timed out.
◗ Refer to your wireless client adapter's AOSS
supplement to initiate the wireless client adapter's AOSS
mode.
◗ It typically takes 10-15 seconds for the AOSS light to
stopashingaftertheAOSSbuttonhasbeenpressed
onthewirelessclientadapter.Oncecongurationis
complete, the AOSS light will remain steady. Please
refer to your wireless client adapter's supplement for the
remainder of the setup.
AOSS