Setup guide

◗ Advanced

Select this option for advanced settings of your AirStation. For more information

on conﬁ guring advanced settings of your AirStation, please refer to the User

Manual on the AirNavigator CD or the Buffalo Wireless Support Web Site:

http://www.buffalotech.com/wireless/support

◗ Default Settings

If at any time you wish to restore settings to factory defaults, press the red INIT

button on the back of the AirStation for 15 seconds. During this process the red

DIAG light will light up. Once it has lit up, you can stop pressing the INIT button.

The restore process can take up to two minutes.

This completes the basic AirStation Conﬁ guration. To change advanced settings,

please consult the Online Manual on the CD-ROM or go to the Buffalo Support

Web Site: http://www.buffalotech.com/wireless/support

◗ DSL

Select this option if your internet

connection is provided by a

DSL provider. Most DSL providers

require PPoE settings to be entered.

◗ Cable

Select this option if your internet

connection is provided through your

cable provider. Most cable providers

require no aditional settings except to

obtain an IP.

■ NOTE: After selecting either the DSL or Cable wizard, please choose

the proper selections that are applicable to your internet service provider. A

veriﬁ cation test will be run at the end of the wizard.

The ﬁ rst page of the conﬁ guration offers 3 distinct buttons for DSL, Cable, and

Advanced settings. Select the appropriate type of internet service, referencing

the information you collected during the preparation steps if needed.