User manual

WHR-HP-GN / WHR-HP-G300N User Manual 18
Chapter 4
Conguration
ThischapterexplainstheadvancedsettingsfortheAirStation.Tochangeadvancedsettings,usethe
AirStation'sweb-basedcongurationutility.
How to Access the Web-Based Conguration Utility
To display the conguration of the AirStation, follow the procedure below.
1
2
3
Launchawebbrowser.
Entertherouter’sLAN-sideIPaddressintheaddress
eld,andpressthe"Enter"key.
Note:
･
TheAirStation’sdefaultLAN-sideIPaddressdependsonthepositionofthemodeswitch.
  Inroutermode:192.168.11.1
  Inbridgemode:192.168.11.100(*)
  Note: Iftherouterswitchissetto"AUTO"andtheunitisworkinginbridgemode,anIPaddressis
assignedtothisunitfromaDHCPserver.
･
IfyouchangetheIPaddressofthisunit,usethenewIPaddress.
Whenthisscreenappears,enter“root”
(in lower case) for the user name and the
password that you set during initial setup.
Click“OK”.
Note:
･
By default, the password is blank (not set).
･
Ifyouforgetyourpassword,holddown
the Reset button (page 11) to initialize all
settings. The password will then be blank.
Note that all other settings will also revert to
their default values.