User manual
WHR-HP-GN / WHR-HP-G300N User Manual 100
Appendix E
Regulatory Compliance Information
Federal Communication Commission Interference Statement
ThisequipmenthasbeentestedandfoundtocomplywiththelimitsforaClassBdigitaldevice,pur-
suanttoPart15oftheFCCRules.Theselimitsaredesignedtoprovidereasonableprotectionagainst
harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will
notoccurinaparticularinstallation.Ifthisequipmentdoescauseharmfulinterferencetoradioor
television reception, which can be determined by turning the equipment o and on, the user is en-
couraged to try to correct the interference by one of the following measures:
•Reorientorrelocatethereceivingantenna.
•Increasetheseparationbetweentheequipmentandreceiver.
•Connecttheequipmentintoanoutletonacircuitdierentfromthattowhichthereceiveris
connected.
•Consultthedealeroranexperiencedradio/TVtechnicianforhelp.
FCC Caution:
Anychangesormodicationsnotexpresslyapprovedbythepartyresponsibleforcompliancecould
void the user’s authority to operate the equipment.
ThisdevicecomplieswithPart15oftheFCCRules.Operationissubjecttothefollowingtwocondi-
tions: (1) This device may not cause harmful interference, and (2) this device must accept any inter-
ference received, including interference that may cause undesired operation.
FCC ID:
WHR-HP-G300N: FDI-09101621-0
WHR-HP-GN: FDI-09101567-0
Important Note - FCC Radiation Exposure Statement:
ThisequipmentcomplieswithFCCradiationexposurelimitssetforthforuncontrolledequipment.
This equipment should be installed and operated with minimum distance 20cm between the radia-
tor and your body.
Thistransmittermustnotbeco-locatedoroperatinginconjunctionwithanyotherantennaortrans-
mitter.
Theavailabilityofsomespecicchannelsand/oroperationalfrequencybandsarecountrydepen-
dent and are rmware programmed at the factory to match the intended destination. The rmware
setting is not accessible by the end user.