User manual

TeraStation III iSCSI User Manual 33
For best results, plug your TeraStation in to a UPS (Uninterruptible Power Supply). This will protect it from many kinds of
power outages. When connected to a UPS, The TeraStation can be automatically shut down to protect data. Congure
the following settings to use the TeraStation with a UPS.
1
Connect the UPS to a wall socket.
2
Connect the AC cable of the TeraStation to the UPS.
3
Connect the UPS and the TeraStation with either a USB cable or a serial cable.
4
Turn on the UPS, then turn on the TeraStation.
5
6
Your UPS is now congured.
Notes:
• Refer to Bualo Technology’s website (www.bualotech.com) for compatible UPS units.
• If the TeraStation unit has automatically shut down due to a power outage, do not turn the unit on until power is
restored. Doing so will force the unit to run on the battery of the UPS, and thus will not shut down automatically a
second time, even if the battery is low.
• If UPS Recovery function is enabled, the UPS will automatically restart the TeraStation when normal power is restored.
1 Congure the desired settings.
If your TeraStation is connected directly to the UPS, select synchronize with
UPS connected to this TeraStation. To have the UPS shut down multiple
TeraStations on the same network, select synchronize with UPS connected to
other TeraStation on the network and enter the IP address of the TeraStation
that is connected directly to the UPS in the eld below.
2 Click Save.
UPS Settings
1 In Settings, navigate to Maintenance - Power Management - UPS Settings.
2 Click Modify Settings.