User manual

TeraStation III iSCSI User Manual 11
Reconnect a TeraStation
To reconnect a TeraStation that was previously removed, register the device and connect a volume via the procedure
below.
1
Connect the TeraStation and power it on.
2
Click Start - All Programs - BUFFALO - iSCSI Connection Tool - iSCSI Connection Tool to open the iSCSI Connection
Tool.
For Windows 8, click the iSCSI Connection Tool .
3
4
The volume you just connected will be added as a local drive under Computer or My Computer.
Notes:
• If a volume is not formatted, it will not be added as a local drive. To format, select Disk Management from Con guration
menu in iSCSI Connection Tool.
• To connect multiple volumes at once, choose Connect volumes from Con guration menu.
• To set the volume to automatically connect when the computer starts up. check Connect on Start Up.
• With Windows XP or Windows 2000, you cannot connect to volumes larger than 2 TB. If you have a volume that
exceeds 2TB, use the Logical Volume Manager (LVM) tool to create volumes smaller than 2TB before connecting.
2 Click Register the iSCSI Device.
Note:
If access control restrictions were set (from Basic - Security), you will be
asked to enter the username and password before continuing.
1 Select a TeraStation from Target.
2 Click Connect.
Note:
If access control restrictions were set (from iSCSI Volumes - Create
Volume), you will be asked to enter the username and password before
continuing.
1 Select the volume to connect to.