User manual

TeraStation IS Setup Guide 7
Chapter 2
Using the iSCSI Hard Disk Connection Tool
iSCSI Hard Disk Connection Tool
When you set up the TeraStation with TeraNavigator, the iSCSI Hard Disk Connection Tool was installed. You will use
this tool to connect to the TeraStation.
To launch: Click “Start” - “All Programs” - “BUFFALO”-”iSCSI Hard Disk Connection Tool”-”iSCSI Hard Disk Connection
Tool”.
Name Meaning
Target product Select a TeraStation from the drop-down list. Any iSCSI TeraStations on the LAN should be available.
“Register the iSCSI Hard Disk” registers all volumes of the selected TeraStation to your computer.
If a TeraStation is already registered, click “Remove the registered iSCSI Hard Disk” to unregister all
volumes of that TeraStation.
Model Name TeraStation's model name
Series Name TeraStation's series name
IP Address TeraStation's IP address.
Subnet mask TeraStation's subnet mask.
MAC Address TeraStation's MAC address.
Firmware TeraStation's rmware version.
iSCSI Service Shows whether the iSCSI service of the TeraStation is running or stopped.
Volume Select individual volumes from a registered TeraStation.
Select a volume and click “Connect". The selected volume will be recognized as a local drive on your
computer in My Computer.
Volumes will not be visible until the TeraStation is registered above.
If IP address restrictions are set, volumes are displayed only on computers with allowed IP addresses.
If a volume is connected, click “Remove" to disconnect it.