User manual

TeraStation IS Setup Guide 52
Maintenance
Email
Notification
Click “Modify
Settings”
to change
settings.
Click
“Send Test
Message”
to send a
test email
to the email
address
which has
been set.
Notication Enable to use Email notication.
SMTP Server
Address
Enter the address of your SMTP mail server.
SMTP Port No. Enter the SMTP Port Number. If this is left blank, the standard port number (25) is used.
If user authentication is set to “Disabled” or “POP before SMTP”, then port 25 is used
regardless of the number entered in this eld.
Authentication
Type
Select Authentication Type from “POP before SMTP”, “LOGIN (SMTP-AUTH)”, and “CRAM-
MD5(SMTP-AUTH/CRAM-MD5)”.
POP3 Server
Address
Enter the address of the POP3 email server
POP3 Port No. Enter the POP3 Port Number. If this is left blank, the standard port number (110) is used.
SSL/TLS When "LOGIN (SMTP-AUTH)" and "CRAM-MD5 (SMTP-AUTH/CRAM-MD5)" are selected for
Authentication Type, specify either "SSL" or "TLS".
Username Enter the username for authentication.
Password Enter the password for authentication.
Subject Specify the subject line that emails will be sent with. Alphanumeric characters are
supported. Do not use two-byte characters.
Recipient(s) Enter the email address of the recipient, and click “Add". You can register up to 5 email
addresses as recipients.
Report Select the contents for email notications.
• HDD Status Report
Sends the drive status.
• Fan Failure
Sends a message if a fan error occurs.
• Disk Error
Sends a message if a drive error occurs.
• System Alert
Sends a message when the TeraStation is rebooted or shut down, or its RAID
conguration is changed.
Syslog
Click “Modify
Settings”
to change
settings.
Syslog You may elect to send logs to a syslog server. “Enable" Log information transmission,
enter the IP address of the syslog server, and select “Save" to transmit logs to a syslog
server.
Maintenance