User manual

TeraStation IS Setup Guide 48
Network
IP Address Settings
Click “Modify Settings” to
change settings.
*The LAN cable connected to
LAN port 2 should be set
for Ethernet 2.
DHCP If a DHCP server is available, enable DHCP to assign IP addresses
automatically.
IP Address If not using DHCP, enter an IP address manually.
Subnet Mask Set a subnet mask.
Default
Gateway
Address
Specify the IP address if the default gateway if it exists.
Primary DNS
Server
Species an IP address for the primary DNS server.
Secondary
DNS Server
Species an IP address for the secondary DNS server.
Ethernet Frame Size
Click “Modify Settings" to
change settings.
*The LAN cable connected to
LAN port 2 should be set for
Ethernet 2.
Ethernet
Frame Size
You can improve data transmission speed by increasing the maximum
amount of data that can be sent at once.
• 1518 bytes (Default)
• 4102 bytes (Jumbo Frame)
• 7422 bytes (Jumbo Frame)
• 9694 bytes (Jumbo Frame)
Port Trunking
Click “Modify Settings" to
change settings.
Port Trunking Set this option to connect 2 Ethernet ports to the TeraStation. The
following settings are available:
Disable: Do not use port trunking.
Round-robin policy - Sets a round-robin policy for fault tolerance and
load balancing.
Active-backup policy - Sets an active-backup policy for fault tolerance.
XOR policy - Sets an XOR (exclusive-or) policy for fault tolerance and load
balancing.
Broadcast policy - Sets a broadcast policy for fault tolerance.
Dynamic link aggregation - Sets an IEEE 802.3ad dynamic link aggregation
policy.
Adaptive transmit load balancing (TLB) - Sets a Transmit Load Balancing
(TLB) policy for fault tolerance and load balancing
.