User manual

TeraStation IS Setup Guide 45
Chapter 8
Conguration Utility
Common Settings
Common Settings (Displayed on the left side of the screen)
iSCSI Service
Click “OFF" to stop iSCSI service. Click “ON" to start iSCSI service. Stop iSCSI service before
creating or extending volumes,
Name Displays the TeraStation’s name.
Firmware version Displays the TeraStation’s rmware version number.
IP Address Displays IP address of the TeraStation’s LAN ports 1 and 2.
Place Displays the Place from “Basic" - “Settings" - “Management Information".
Manager Displays the Administrator from “Basic" - “Settings" - “Management Information".
Clients Displays connected client
Locate TeraStation Click to make the TeraStation beep.
Restart/Shutdown
To restart the TeraStation, click “Power Management”, then “Restart". To turn off the
TeraStation, click “Shutdown” under “Shutdown TeraStation” screen.
Logout (displayed on the upper
right of the screen)
Log out of the Conguration Utility.
The following options can be set from the conguration screens.
iSCSI Volumes
iSCSI Volumes
iSCSI Volumes
iSCSI Volumes To add volumes, click “Create Volume".
To edit a volume, click a volume name.
Select a volume and click “Delete Volume" to delete the volume.
Click “Refresh" to update the volume information.
Select a volume and click “Active" will enable the iSCSI service for the selected volume.
Select a volume and click “Inactive" will disable the iSCSI service for the selected volume.
Note: If the IP address of the computer is displayed in the iSCSI volume screen even
though the iSCSI volume is not connected to the computer, enabling or disabling
the iSCSI volume or LVM will fail.
Turning off or disconnecting the computer without disconnecting the drive with
the iSCSI HD Connection Tool may cause this symptoms. If this happens, connect
the iSCSI volume with the iSCSI HD Connection Tool after rebooting the computer,
or stop the iSCSI service once and perform enabling/disabling operation of iSCSI
Volume or LVM.