User manual
TeraStation IS Setup Guide 43
Port trunking (link aggregation) allows you to connect the TeraStation to two Ethernet ports for increased speed
and reliability. Your hub or switch must support IEEE 802.1AX-2008 to use port trunking. Turn to the next page
for instructions on conguring port trunking on the TeraStation.
The TeraStation supports the following port trunking modes:
Disabled: Port trunking is not used.
Round-robin policy * - Sets a round-robin policy for fault tolerance and load balancing.
Active-backup policy - Sets an active-backup policy for fault tolerance.
XOR policy * - Sets an XOR (exclusive-or) policy for fault tolerance and load balancing.
Broadcast policy - Sets a broadcast policy for fault tolerance.
Dynamic link aggregation * - Sets an IEEE 802.3ad dynamic link aggregation policy.
Adaptive transmit load balancing (TLB) - Sets a Transmit Load Balancing (TLB) policy for fault tolerance and
load balancing.
* Congure your switch for the appropriate port trunking mode before conguring these modes on the
TeraStation.
Using Port Trunking
Note
■ After conguring Port Trunking, reboot the TeraStation with the power button. If you fail to reboot it,
network communication may become unstable.