User manual

TeraStation IS Setup Guide 15
Create Volume
By default, one volume uses all available space on the TeraStation. If you delete the factory volume, you may
create up to 10 volumes. Different volumes can be connected to different computers, but each volume can
only be connected to a single computer.
Notes:
Deleting the default volume will delete all data from the TeraStation. Back up any important data
before making any configuration changes!
Enable LVM (previous page) to delete or create volumes.
1
2
3
4
Click “Save”.
5
Turn back on the iSCSI service.
Note: To start iSCSI service for the target volume only, navigate to “iSCSI Volumes” - “iSCSI
Volumes”, select the target volume, and click “Active”.
You have created a new volume.
Note: To use the new volume, you need to connect it (page 11), and format it with Windows Disk
Management. You may open Disk Management from the iSCSI hard disk connection tool by clicking
“Launch (Disk Management)" from the “Setup” menu.
Enter “Volume Name", “Volume Description", “Disk Area", and
“Size".
Turn off the iSCSI service on the left side of the screen.
Note: To stop iSCSI service for the target volume only,
navigate to “iSCSI Volumes”-”iSCSI Volumes”, select the
target volume, and click “Inactive”.
Navigate to “iSCSI Volumes" - “iSCSI Volumes". Highlight
the default volume and click “Delete Volume”. Then, click
“Create Volume".