User manual

TeraStation IS Setup Guide 11
Reconnect a TeraStation
To reuse a TeraStation that you previously removed, follow the instructions below to register it and connect a
volume.
1
Connect the TeraStation and power it on.
2
Click “Start” -”All Programs”-”BUFFALO”-”iSCSI Hard Disk Connection Tool”-”iSCSI Hard Disk
Connection Tool” to open the iSCSI Hard Disk Connection Tool.
3
4
The volume you just connected will be added as a local drive to Computer (My Computer).
Notes:
If a volume is not formatted, it is not added as a local drive. To format, select “Launch Disk Management” from
“Setup” in the iSCSI Hard Disk Connection Tool’s menus.
To connect multiple volumes at once, choose “Connect some Volumes” from the Setup menu.
To connect more than one volume at a time, choose “Connect some Volumes” from the “Setup” menu.
To always connect a volume or volumes, check “Connect on Start Up".
With Windows XP or Windows 2000, you cannot connect to volumes larger than 2 TB. Use Logical Volume
Manager (LVM) to create volumes smaller than 2 TB, then connect.
2 Click “Register the iSCSI Hard Disk”.
Note: If you set access restrictions for “Access Control (Whole System)”
from the “Basic” menu, enter the user name and password to
continue.
1 Select the TeraStation from “Target product”.
2 Click “Connect”.
Note: If you set access restrictions in “iSCSI Volumes”-”Create Volume”-
”Access Control”, enter the user name and password to continue.
1 Select the volume to connect to.