Specifications

CONAX BUFFALO TECHNOLOGIES TSD 43.021
Rev. ORIG
Page 8 of 28
6.2 CONFIGURATION
6.2.1 Connect the PA-400 programming adapter into the proper serial port of the PC.
6.2.2 Click on the Configuration icon to start the program.
6.2.3 Connect the plug on the transmitter side of the PA-400 to the 6-pin jack on the
indicator, behind the front bezel (lens) in the lower-right corner. See Figure 2.
6.2.4 When the connection is made and the software recognizes that the indicator is
connected, the toolbar icons will become highlighted (enabled). Normally, the
software is installed with the “Auto Upload” option enabled. In this case the
current configuration stored in the indicator will be loaded into the software. If the
option has been disabled, click the “UPLOAD” icon . This will begin the
communication process between the indicator and the PC. Once completed, the
transmitter’s calibration and configuration settings will be loaded into your PC.
See Figure 3.
Figure 3 – Main Screen of the SPMconfigurator32 Program (Indicator attached)