User manual

71
6 Click to the right of “UPS Sync”.
7 Click Edit.
8 Configure the desired settings, then click OK.
Notes:
• If the LinkStation is connected directly to a UPS, select “Sync with UPS connected to this LinkStation”. If a differ-
ent LinkStation is connected to the UPS, select “Sync with UPS connected to another LinkStation on the same
network”. After making this selection, enter the IP address of the LinkStation that will be the sync source in “Other
LinkStation’s IP Address”.
• When the LinkStation is rebooted after an automatic shutdown due to a power outage or other power supply
problem, verify that the power supply has been restored. If the LinkStation is turned on while it is still running on
the UPS and without the power supply restored, automatic shutdown is not performed, even after the specified
time has elapsed.
• If the power supply from the UPS to the LinkStation is stopped and restarted when UPS recovery is enabled, the
LinkStation is automatically restarted.
Restoring Factory Defaults
To initialize the LinkStation to its factory default,settings, follow this procedure.
Initializing from Settings
1 In Advanced Settings, click Management.
2 Click the icon to the right of “Restore/Erase”.
3 Click Initialize LinkStation.