User manual

Dismount and remove the USB device when installation is complete.

2 Connect the USB device to the LinkStation’s USB port.

Note: With the USB device server enabled, you may connect a single USB hub to the LinkStation. Up to 15 USB

devices may be connected to the hub. Don’t connect more than one bus-powered drive at a time. Use a separate

AC power connection for each device if possible. Connecting more than one bus-powered device at a time may

damage both the LinkStation and the devices.

3 In Advanced Settings, navigate to File Sharing - Folder Setup and select the USB device connected to the

LinkStation.

Note: USB device server and DLNA are not compatible. Disable DLNA protocol support if using USB device server.

4 Move the USB device server switch to the position to enable the USB device server.

You can also enable the USB device server from Easy Admin.

Note: When the USB device server is enabled, other functions that use the USB port won’t be available.

5 To install Network-USB Navigator, click USB Device Server in Easy Admin or navigate to Services - USB Device Server -

USB Device Server in Advanced Settings. You’ll need administrator privileges to install the software.

Connecting with Network-USB Navigator

1 Launch Network-USB Navigator.

For Windows:

Navigate to (All) Programs - BUFFALO - Network-USB Server, then click Network-USB Navigator. On Windows 8, click

Network-USB Navigator from the start screen.

For Mac:

Navigate to Macintosh HD - Applications - BUFFALO - Device Server - Network-USB Navigator.

2 Select the USB device, then click the button to connect.