User manual

45
4 Click Close.
5 In Advanced Settings, click to the right of “Users”.
6 Change the user’s primary group to the group with the quota, then click OK.
7 Click Close.
8 Click the icon and select Restart to apply the quota settings.
Hard Drive Replacement
If a drive fails, NAS Navigator2 and Settings will show a error message.
Notes:
• Do not replace a running drive while the LinkStation is turned on. Power down the LinkStation before changing
the drive. While the LinkStation is running, never unplug or remove drives without dismounting them first.
• The replacement drive should be a OP-HD/LS series drive, available from Buffalo. Using a different drive might
cause your LinkStation to malfunction.
• Use a Buffalo OP-HD/LS series drive of the same size or larger for the replacement drive. If a larger drive is used,
the extra space will not be usable in a mirrored RAID array.
• To avoid damaging the LinkStation with static electricity, ground yourself by touching something made of metal
before handling any sensitive electronic parts.
• After a drive is replaced, it takes about 30 minutes before normal file reading and writing are restored. Settings
may not be accessible during this period.
• Do not change the order of the hard drives in the LinkStation. For example, pulling out drive 1 and replacing it
with drive 2 may cause data to be corrupted or lost.
• If a new drive is not recognized after installing it, click Rediscover Disk in Settings.
Hard Drive Replacement Examples
1 Turn the LinkStation off and remove all cables.
2 Squeeze the left side of the front panel and pull the panel off.