Operation Manual

LinkStation User Manual 136
Appendix
Error code Error Details
E01 Problems in DRAM DATA LINE. Contact a Bualo service center for repair.
E02 Problems in DRAM ADDRESS LINE. Contact a Bualo service center for repair.
E03 Problems in RTC CHIP. Contact a Bualo service center for repair.
E04 Fail to extract Kernel. Contact a Bualo service center for repair.
E06 The rmware is corrupted. Contact a Bualo service center for repair. Wait for 5
minutes to show "E04" and turn o, or turn the power switch o.
E07 Hard disks are not detected. If the hard disks are connected, Contact a Bualo service
center for repair.
E10 UPS error. Operating from UPS battery. System will be safely shut down based on
the conguration conditions. After the LinkStation shuts down, ensure that power is
supplied to the UPS. If there is no problem, briey press the function switch on the
LinkStation (pressing and holding down the switch will not work).
E11 Fan Error. The fan is spinning too slowly or has stopped. Move the unit to a cool place
with good airow and no objects blocking the fan. If the LED remains lit, replace the
fan with part OP-FAN/LS, sold separately.
E15 Hard disk IO error. Contact a Bualo service center for repair.
E16 The hard disk is not connected or is malfunctioning. Contact a Bualo service center
for repair.
E17 Internal controller error. Contact a Bualo service center for repair.
E20 The circuit board may be damaged. Disconnect and then reconnect power. Reboot
the LinkStation. If the error persists, Contact a Bualo service center for repair.
E21 Internal controller error. Contact a Bualo service center for repair.
E22 Mount error. Contact a Bualo service center for repair.
E23 The hard disk may be damaged. Contact a Bualo service center for repair.