User manual

30
WBR-G54 User Manual
8
FCC / CE Information
Federal Communication
Commission Interference
Statement
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one of
the following measures:
• Re-orient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is con-
nected.
• Consult the dealer or an experienced radio/TV
technician for help.
FCC Caution: To assure continued compliance, (example
- use only shielded interface cables when connecting
to computer or peripheral devices). Any changes or
modifications not expressly approved by the party
responsible for compliance could void the user’s authority
to operate this equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2)
this device must accept any interference received, including
interference that may cause undesired operation.
IMPORTANT NOTE:
FCC RF Radiation Exposure Statement:
This equipment complies with FCC RF radiation exposure
limits set forth for an uncontrolled environment. This
equipment should be installed and operated with a
minimum distance of 20 centimeters between the radiator
and your body.
This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
R&TTE Compliance Statement
This equipment complies with all the requirements
of the DIRECTIVE 1999/5/EC OF THE EUROPEAN
PARLIAMENT AND THE COUNCIL of 9 March 1999
on radio equipment and telecommunication terminal
Equipment and the mutual recognition of their conformity
(R&TTE). The R&TTE Directive repeals and replaces in
the directive 98/13/EEC (Telecommunications Terminal
Equipment and Satellite Earth Station Equipment) As of
April 8, 2000.
Safety
This equipment is designed with the utmost care for
the safety of those who install and use it. However,
special attention must be paid to the dangers of electric
shock and static electricity when working with electrical
equipment. All guidelines of this manual and of the
computer manufacturer must therefore be allowed at all
times to ensure the safe use of the equipment.
EU Countries intended for use
The ETSI version of this device is intended for home
and office use in Austria, Belgium, Denmark, Finland,
France (with Frequency channel restrictions), Germany,
Greece, Iceland, Ireland, Italy, Luxembourg, Norway, The
Netherlands, Portugal, Spain, Sweden, Switzerland and
United Kingdom.
The ETSI version of this device is also authorized for use
in EFTA member states Iceland, Liechtenstein, Norway
and Switzerland.
EU Countries Not intended for use
None.
Potential restrictive use
France: Only channels 10,11,12, and 13.