User manual

7 8 9 11 13 14 15 17
12
1610
Chapter 1 Product Overview
- 7 -
Back Panel
7
Power Connector Connect the power adapter here.
8
Power button This button turns the power on and o .
9
LAN Port These ports may be connected to computers, hubs, or other network
devices. With Auto-MDIX, you can use straight or crossover Ethernet
cables. LAN port 1 supports PoE.
10
Function expansion
USB port
This extra USB port will be used for additional functionality in the future.
With current  rmware releases it is not enabled yet.
11
USB Port Connect a USB memory device here to upgrade  rmware or save logs.
12
USB Eject Button Before unplugging a USB memory device, hold down the USB eject
button for 3 seconds. The USB LED will begin to blink. It’s then safe to
unplug the memory device.
13
USB LED (Green)
On: USB memory device is being used.
Randomly blinking: USB memory device can be removed.
14
RJ-45 serial console
port for settings
This serial console port will be used for additional functionality in the
future. With current  rmware releases it is not enabled yet.
15
Reset Button To reset all settings, hold down this button until the Diag LED comes on
(about 3 seconds). Power must be on.
16
AOSS/WPS button To initiate AOSS (or WPS), hold down this button until the wireless LED
 ashes twice (about 1 second).
17
Maintenance port For factory use only.