User manual

20
Using the Function Button
Initialization - You can easily bring your LinkStation EZ back to factory
settings with the following steps.
1. Move the power switch to the ‘Off’ position. The LinkStation EZ will
shut down after about 45 seconds.
2. While holding down the function button, move the power switch to the
‘On’ postion. The function button will begin to ash blue.
3. While the function button is still ashing, hold it pressed down for six
seconds.
Dismount - Before disconnecting USB devices from the LinkStation EZ,
they should be dismounted. Hold the function button down until the
function LED glows blue, and then turns off. It’s now safe to unplug your
USB device.
Note: Unplugging USB devices without dismounting them rst may
corrupt your data!