User manual

LinkStation Expansion

LinkStation EZ has a USB 2.0 port on the rear. This port can be used for adding an external

USB Hard Drive or a USB Printer, or for connecting to a UPS. LinkStation will share connected

USB devices, allowing everyone on the network to use them. To connect a USB hard drive to your

LinkStation, simply plug it into the USB port.

Once your USB hard drive is connected, turn to the “Disk Management” section of this manual

for information on conguring your LinkStation to use it.

To congure a USB printer, see “Installing a Printer”.

To congure UPS settings, see page 57.

Note that only one USB device may be used at a time. USB hubs are not supported.