User`s guide

80 007-4403-003
6: Virtual Clips
clip-name Specifies the segmented virtual clip for the extraction of segment
information for the copy into the non-virtual clip destination. The
segmented virtual clip must have the movie/vclip format.
new-clip Specifies a non-virtual clip destination.
start Specifies the start timecode for the non-virtual output.
Saving, Closing, and Removing Virtual Clips
To save, close, or remove a virtual clip, use the following MVCP commands, respectively:
CSAV [clip-name]
CCLS [
clip-name]
CRM [
clip-name]
clip-name Specifies the name of the clip to save, close, or remove. If clip-name is not
specified, the most recently created or opened clip is saved, closed, or
removed.
Note: CSAV, CCLS, and CRM work with virtual and non-virtual clips.
Working with Segments
The MVCP commands in this section work only with segment-formatted clips; currently
the only format supported is movie/vclip.
Once you create or open a vclip, you add segments to or remove segments from it to
revise the vclip.
Adding Segments to Vclips
The CUPS (update) command, defined as follows, adds segments to vclips:
CUPS clip-name src-op dest-op trk-mask in out src-clip src-trk-mask src-in src-out
clip-name Specifies the name of the vclip to which you add a segment.
src-op Specifies the operations on the segment in the vclip: