Full Product Manual

SAFETY INSTRUCTIONS
To minimize the risk of electric shock
do not use extension leads to connect the
product to the power supply.
Ensure that the receptacle is properly
located.
Parts of the equipment cannot be placed
above the hot tub during usage.
Parts under electrical power – except those
operating with voltage not exceeding 12V -
must be inaccessible for persons in the hot
tub. The grounded device must be connected
to a fixed socket with fixed wiring. Electrical
parts – except remote controllers – must be
positioned so as not to fall into the hot tub.
The electrical installation must meet the
local standard requirements.
To avoid electric shock do not use the hot
tub in rain.
Water attracts children. Always place and lock
the cover on the hot tub after each usage.
Do not bury cables into the ground! Place
the cables so that lawnmowers, trimmers,
and similar devices will not reach them.
Do not force push the control panel up nor
down and do not place heavy objects on it
after installation.
Keep pets away from the hot tub to avoid
damage.
Do not use the device if there is the slight-
est chance of water in the hot tub being
frozen.
Only use accessories approved by us. The
use of accessories not approved by us may
void the warranty.
Choking hazard. Particular attention need
to be paid to children during usage. To
avoid accidents only allow children to use
this hot tub under adult supervision.
To prevent damage to the pump the hot tub
can only be operated if it has been filled
with water.
If you feel uncomfortably or sleepy, leave
the hot tub immediately.
Never add water to the chemicals. Always
be cautious when adding chemicals to the
hot tub water to avoid inhaling vapors
and possible effects of inhaling undiluted
chemicals and splatters.
Only place the hot tub on a surface that
can support its weight.
Inspect the unit before use. contact the ser-
vice provider stated in this manual if any
of the parts were damaged or missing upon
purchase. Ensure that the parts of the unit
are those which you intended to buy.
In.clear safety warnings
Beyond the previous warnings, please also
pay attention to the undermentioned ones
read this manual carefully, always follow
its instructions, and retain it. This manual
contains important information about the
installation, operation, and safety recom-
mendations of the in.clear unit. Safe instal-
lation and usage is your responsibility.
The in.clear unit must be connected to a
network protected by a ground fault circuit
interrupter (GFCI) of the maximal nominal
fault current value of 30mA.
Ensure that the entire power supply is turned
off before the in.clear unit is installed.
If the power cord is damaged, it must be
replaced by the manufacturer, an autho-
rized service provider, or qualified profes-
sionals to avoid emergencies.
Always use a proper electric cable for sup-
ply of current to the in.clear unit.
When installing the in.clear Automatic
Bromine Generator local and international
electrical regulations must be com- plied with.
Clean or replace the filter cartridge at
regular intervals, otherwise part of the bro-
mine produced by the in.clear unit will be
consumed by oxidation of contamination
accumulated in the filter.
11