Installation Instructions

Boiler block assembly

Logano G615 - Subject to technical modifications

Fig. 11 Driving nipples home

B Coat the packing grooves with adhesive (primer).

Fig. 12 Coat the packing grooves with adhesive

(primer)

1 Packing grooves

B Insert the flexible sealant rope on the front of the rear

section, starting around the top hub, into the packing

grooves, and press in lightly.

B At the butt joints, overlap the sealant rope by approx.

3/4" (20 mm) and press firmly together.

B Do not let sealant rope overlap at the left and right of

the butt joints (Æ Fig. 13, [3]).

Fig. 13 Inserting sealant rope

1 Packing grooves

2 Sealant rope

3 Butt joints

Prepare the first intermediate section (with top

supply connection):

B File down any burrs on the hub.

B The packing springs must be clean and dry. Clean if

necessary.

B Clean the hub sealing faces with a rag soaked in

mineral spirit or gasoline.

Fig. 14 Preparing the center section

1 Sealing face of the hub

2 Packing springs

Unroll the required length of sealant rope

from the spool supplied. Peel the backing

paper from the sealant rope when inserting

into the packing groove (do not stretch).

1-1/4"

(32 mm)

1-3/4" (43 mm)