User's Manual

Installation:
The Budderfly RF Multi-Way Switch may be used in new installations or to replace an existing wall switch. It could be used either as
a 2-way switch, or as a 3-way switch. The wiring steps for both configurations are explained in the following diagrams:
2-Way Configuration:
AC
BUDDERFLY
Multi-Way Switch
HOT
(Usually Black)
LIGHTING
LOAD
GROUND
(Green/Yellow)
HOT
(Black)
Traveler 2
(Blue)
Traveler 1
(Red)
NEUTRAL
(Usually White)
Legend:
Wiring Nuts
Not
Connected
Warning
RISK OF FIRE
RISK OF ELECTRICAL SHOCK
RISK OF BURNS
Exercise extreme caution when using Budderfly switching devices to control appliances.
To avoid the risk of Fire, Electrical Shock, Burns or other hazards we recommend the
following:
x Install the Budderfly switches indoor only.
x Never use the Budderfly switches to control medical and/or life support
equipment.
x Do not use the Budderfly switches to control electric heaters or any other
appliances which may present a hazardous condition due to unattended or
unintentional power on control.
x Never use the Budderfly switches with loads that exceed the maximum rating
specified.
WARNING ʹELECTRICAL SHOCK HAZARD
x Turn OFF the power to the branch circuit for the switch and lighting
fixture at the service panel.
x
All wiring connections must be made with the POWER OFF to avoid
personal injury and/or damage to the switch.