User's Manual
Installation:
The Budderfly Outlet may be used in new installations or to replace an existing Outlet.
The wiring schematic will be as per below:
1. At the circuit breaker or fuse panel, disconnect the power for all of the circuits in the switch junction box.
2. Double Check that the power is OFF to the Outlet by trying to turn on a device connected to the plug before continuing.
3. Remove the wall plate from the plug you are replacing. Then, unscrew the plug itself and pull it out from the junction box.
4. Disconnect the wires from the plug you are replacing.
5. Follow the Wiring information provided below and connect the wires as follows:
- Connect the GROUND wire (usually Bare Copper or Green) to the Ground wire of Budderfly Outlet (Yellow & Green).
- Connect the LINE wire (usually Black) that comes from the electrical service panel to the HOT wire of Budderfly Outlet
(Black).
- Connect the NEUTRAL wire (usually White) to the Neutral wire of Budderfly Outlet (White).
6. After you have connected all of the wires, ensure that all of the wire connectors are firmly attached and that there is no
exposed copper except for the GROUND wire.
7. Gently place Budderfly Outlet into the junction box. Then, screw the Outlet into place.
8. Reinstall the wall plate
9. Enable power to the Outlet from the circuit breaker or fuse panel
10. Add the device address to the Budderfly software.
WARNING –ELECTRICAL SHOCK HAZARD
Turn OFF the power to the branch circuit for the Outlet at the service
panel.
All wiring connections must be made with the POWER OFF to avoid
personal injury and/or damage to the Outlet.
Wiring Information
Important: Budderfly Outlet is rated for and intended to only be used
with copper wire.
Use 12 AWG or larger wires suitable for 80
o
C.
Remove 3/4" (1.9 cm) of insulation from each wire.
Connect as follows: Twist strands of each end tightly together. Hold bare
ends of wires together and push firmly into wire Nut. Screw Nut
clockwise making sure that no bare conductor shows below the
connector.