Installation Guide

Page 12
INSTALLATION OF
LOGS FOR
TOWNSEND II
MODEL CVFB200(LP)
MODEL CVFB200(NAT)
NOTE: FOR INSTALLATION
OF C100BA HEPPLEWHITE
LOGS SEE PAGE 14.
1. Remove log access door on top of
unit buy removing two (4) phillips
screws. Set access door and screws
aside. (See Figure 11).
2. Carefully insert logs though opening in
top of unit as described on ( Page 13,
figure 13).
3. After placing logs on base, light heater
making sure no logs are contacting
flames, if so, then turn flame off.
Reposition any log contacting flames
so there is no contact with flame.
Relight and check once more. If
correct, turn flame off.
4. Place access door on top of unit and
secure with the two (4) phillips screws.
5. Place the top grate on unit as shown.
(See Figure 12).
FIGURE 11 - REMOVING ACCESS DOOR
FOUR PHILLIPS SCREWS
FOUR PHILLIPS SCREWS
FIGURE 12 - REPLACING ACCESS DOOR AND INSTALL TOP GRATE
GAS LOGS
ACCESS DOOR
TOP GRATE