Installation Guide

Page 7
UNPACKING STOVE
ASSEMBLY FOR
CVFB200, C100BA VENT
FREE STOVE SERIES
1. Carefully remove corrugated box
enclosing stove, leaving unit on
pallet at this time. Remove box that
contains logs , also remove Top
Grate from stove and set aside. Top
Grate will be placed on unit after
being installed in desired location
2. Using phillips head screwdriver,
move screws from hold down
brackets on two of the legs.
3. Using drop cloth or blanket to
protect floor, carefully lay stove
body on back. Remove hold down
brackets from the two legs by
unscrewing two bolts holding
brackets. Now replace two bolts in
bottom of legs. The bolts are used
for leveling adjusters. Place unit in
upright position. .(See Figure 4).
TOP OF
FRONT OF
STOVE
BACK OF
STOVE
SIDE
NOTE: TYPICAL STOVE CABINET MODEL
FIGURE 4
LEVELING BOLTS
BACK