User guide
Table Of Contents
- 1 About this manual
- 2 Safety
- 3 Technical data
- 4 Description of function
- 5 Putting into operation
- 6 Operation
- 6.1 Menu structure of the Vacuum Controller V-850/855 software
- 6.2 Vacuum Controller V-850/855 main screen in Manual mode
- 6.3 Selecting the distillation conditions
- 6.4 Starting a distillation
- 6.5 Vacuum Controller V-850/855 main screen in Gradient mode
- 6.6 General information on buttons
- 6.7 Main menu
- 6.8 Calibrating the pressure sensor
- 6.9 Recirculating chiller
- 6.10 Tips and tricks for a distillation
- 7 Maintenance
- 8 Troubleshooting
- 9 Shutdown, storage, transport and disposal
- 10 Spare parts
- 11 Declarations and requirements
5 Putting into operation
22 V-850/855 Operation Manual, Version E
5.3 Installing the AutoDest probe
1
To install the AutoDest probe proceed as follows:
• Insert the AutoDest probe into the opening at the top of the condenser.
• Push the probe down between the inner condenser coil and the vacuum tube in the center of the
condenser.
• Position the probe as shown in Fig. 5.3. Make sure that the prope tip position corresponds to posi-
tion a in Fig. 5.3.
• Tightened screw cap at the top of the condenser.
• Plug the cable of the AutoDest probe into the AS/SB socket of the controller (position b in the
figure above).
NOTE:
Calibrate the AutoDest probe, see also chapter 6.7.5.
2