Manual

BÜCHILabortechnikAG Installation|5
UltrasonicController 25/46
5 Installation
5.1 Unpacking
1. Unpackthedevice.
2. Checkthedeviceforanydamagescausedbythetransportation.
• Reportdamagesimmediatelytotheresponsibletransportationcompany.
3. Checkforcompletenessoftheproductaccordingtothescopeofdelivery.
4. Keeptheoriginalpackagingforfuturetransportation.
5.2 Ultrasoniccontrollerwithnozzle,installation
Fig.10:InstallationofUltrasoniccontrollerandnozzle
1 Ultrasoniccontroller 2 Feedsolution
3 Ultrasoniccable 4 Compressedspraygas
5 Pulsationdamper 6 Ypiece
7 Ultrasonicnozzle 8 Feedtube
a Compressedcoolinggas“In” b ConnectorforFeedtube
c Connectorforultrasoniccable d Compressedcoolinggas“Out”
1. Insertthenozzle(7)completelyintotheheaterelementontopofthe
B290.
2. PlacetheUltrasonicController(1)ontheproductfeedtableoftheB290.
3. ConnectthepowercordtotheUltrasonicController.
• Useapluginlocationwhichallowstodisconnectthedeviceatanytime.
4. Attachthenozzleusingtheultrasoniccable(3)totheconnectoronthe
rearsideofthecontroller.