Owner manual

5 Putting into operation

33 SpeedExtractor E-916/E-914 Operation Manual, Version D

5 Putting into operation

This chapter describes the installation of the SpeedExtractor and gives instructions on initial start-up.

NOTE

Inspect the instrument for damages during unpacking. If necessary, prepare a status report imme-

diately to inform the postal company, railway company or transport company. Keep the original

packaging for future transport.

5.1 Installation site

Put the instrument on a stable, horizontal surface. Consider the maximum product dimensions and

weight. Obtain the environmental conditions as described in section 3.4, technical data.

Installation prerequisites:

• Do not place any objects on top or below the instrument or parts of it.

• The instrument must be installed with 5 cm clearance to any other objects or walls to allow suf-

ﬁcient cooling.

• Do not store containers, chemicals or other items behind the instrument.

WARNING

Death or serious injuries by use in explosive environments.

• Do not operate the instrument in explosive environments

• Do not operate the instrument with explosive gas mixtures

• Before operation, check all gas connections for correct installation

• Directly withdraw released gases and gaseous substances by sufﬁcient ventilation

CAUTION

Risk of minor or moderate injury by heavy weight of the instrument.

• Consult three further persons to transport the instrument

• Do not drop the instrument

• Place the instrument on a stable, even and vibration-free surface

• Keep limbs out of crushing zone

NOTICE

Risk of instrument damage by liquids or mechanical shocks.

• Do not spill liquids over the instrument or its components

• Do not move the instrument when it is loaded with sample liquid

• Do not drop the instrument or its components

• Keep external vibrations away from the instrument

• Safely attach the instrument to the bench in earthquake prone regions

• Do not operate the instrument without the protection cover installed at the front