Manual

5 Putting into operation
11 SpeedExtractor Record 1.0 Operation Manual, Version A
5 Putting into operation
This section contains all steps to a working setup in chronologic order. If any errors occur, please
check every step carefully again from the beginning.
5.1 Step 1: Installing the program
The program must be installed on the PC following the installation guide on the CD-booklet.
The following prerequisites must be fulfilled:
For installation, the user must hold administrative rights on the computer•
The SpeedExtractor must be disconnected from the computer•
The PC must match the minimum system requirements for this software, see section 3.1•
5.2 Step 2: Connecting a SpeedExtractor
To establish a connection, the following steps must be performed:
Switch on the SpeedExtractor and wait for its bootup process to be finished•
Use the delivered USB cable to connect the extractor to the PC. Check the program status •
indication icon for connection.
Note
The maximum cable length for USB cables without repeater must not exceed 5m
5.3 Step 3: Starting the program
To start the recording software, go to:
Start • > Programs > Buchi > SpeedExtractor Record1.0 > SpeedExtractor Record 1.0
Or double-click the program shortcut icon, which can be found on the desktop (see section 4.1)•
Note
The software is triggered to start recordings syncronized by the SpeedExtractor. Thus the software
must be started before performing an extraction! In case of a record interruption (e.g. loss of mains
power at the SpeedExtractor or broken communication) it is possible to store unfinished records.