User's Manual

MMC Programming

Key Fob

Plug MMC into 120 V AC/220 V AC power.

Take Key Fob slide cover downward to expose its buttons. At lower

right hand side of Key Fob there is a small opening. It is the Key Fob

code button. Take a small paper clip and slide it into the code button

hole. Hold the code button until the red LED comes on. Key Fob is

now coded for this MMC. Try it and make sure it works.

pot

doC

nottuB

Radio Multi-Channel Handsender

Plug MMC into 120 V AC/220 V AC power.

To select the channel you want MMC to be, push the select

button until the LED above the channel is lit and ﬂashing.

Turn over the handsender and look for a small opening in

the center. This is the code button hole. Take a small paper

clip and place one end in the hole. Depress the code button

until the LED on the channel you have selected ﬂashes.

The MMC is now coded to this channel. Unplug the MMC

you have just coded on move on to the next MMC.

Note: If you leave the last MMC plugged in, when you code

another board, the previous MMC will listen to the code and

respond to the new code for the current MMC you are work-

ing on.

Note: Key Fob code is kept in memory also. You can work

Radio Board from the Multi-Channel and Key Fob as well as

the “Select All” button on Multi-Handsender.

elo

not

tuB e

doC

2 1

7 6

tceleS

llA

yret

tnemtrapmoC