User manual

Part 6

Getting more out of Plusdeck2c

3. Controling volume level when converting the tape

1. Line In volume level in Recording control panel controls the input volume level

2. If Line In is not selected or volume level is the minimum, created digital files will

have no sound.

3. If volume level is too high, sound can be distorted. So adjust volume level bar up

and down to optmize sound quality.

4. In most sound cards, 50~70% value should be good but this depends on the

sound card you have.

5. After the sound card setting is optimized, if sound quality of created file is

significantly degraded from the original tape, most likely Line In of the sound card

has gone bad. You should test with a different sound card.

www.plusdeck.com

●

4. Controlling volume level when saving PC output sound

1. Stereo Mix volume level in recording control panel controls the input volume level.

2. If Stereo Mix is not selected or volume level is the minimum, created digital files

will have no sound.

3. If volume level is too high, sound can be distorted. So adjust volume level bar up

and down to optmize sound quality.

4. In most sound cards, 50~70% value should be good but this depends on the

sound card you have.

The name Stereo Mix is called differently depending on

the sound card you have. Some of other names are

What you hear, Wave Out, etc…

Note