User manual

. . . . . . . . . . . . . . . . . . . . . . . . . . . . 1. Understanding about sound volume control
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 2. Optimize played tape sound
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 3. Optimize converted digital sound from tape
sound
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 4. Optimize sound quality recorded onto tape
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 5. Others
1. Open control window
- Windows 98 : Start - Control Panel - Multi Media - Audio
- Windows XP(Classic View) : Start- Control Panel - Sound and Audio Devices
- Windows XP(Category View) : Start- Control Panel - Sound, Speech and Audio
Devices-
Sound and Audio Devices
2. Choose the Audio tab in the sound and audio devices panel.
- To open master volume control panel, click Audio-sound play back ?volume.
- To open record control panel, click Audio-Sound recording-volume.
3. If you do not see line input (line in) under master volume control panel or record control
panel, click Options-Properties(registered information for Windows 98) and set up to see
line
input.
- Choose play under volume control and select items to be shown under volume (line-
out). Master volume control panel is opened to show selected items (line output).
- Choose record under volume control and select items to be shown under volume
(line-in). Record control panel is opened to show selected items (line input)
- This properties window changes shown items at control panel, not at set up.
4. If line input is shown as grayed out under the record control panel, something is set up
incorrectly. In this case, you should contact your soundcard manufacturer and re-install
the
soundcard driver. If the soundcard driver is improperly installed, you can only hear the
output, but the input will not function.
When you play a tape on Plusdeck2 the sound flows as follows:
1. It is normal for the output sound quality from the speaker out jack to be the same as
tape out
sound from a playing tape.
2. When you connect tape out terminal to a speaker directly, it is sound quality of
Plusdeck2.
3. Tape out terminal does not control the volume that goes in or out of the computer. You
can
control the volume of the line-in and line-out terminal through the Control Panel.
4. Each sound card has different volume levels, if sound is too low or high, set up 20% up
or
down from the middle.
5. If master volume or line input is mute you will not hear any sound from playing tape.